Voltage Drop Calculator

HomeDC & solar

3,000 watt inverter cable size

A 3,000 W inverter draws about 294 A from a 12 V battery at full output, 147 A at 24 V and 74 A at 48 V. Here is the cable and fuse for each.

W
One way, battery to inverter. Keep it as short as you can.
85% is a fair figure for full load; check the spec sheet.
%
%

Battery cable

Fill in the circuit, then press the button.

3,000 W inverter cable chart

BatteryInput currentFuse3 ft5 ft10 ft
12 V294 A400 A400 kcmil400 kcmil400 kcmil
24 V147 A200 A2/0 AWG2/0 AWG2/0 AWG
48 V74 A100 A4 AWG4 AWG4 AWG

85% efficiency at nominal battery voltage. Copper, 90 °C ampacity at 125% of input current, 3% drop, one-way length. A battery near cutoff draws about 14% more.

Choosing the system voltage

Above about 2,000 W, 12 V cables become heavy and expensive and the connections run warm. At 3,000 W, 24 V or 48 V cuts the current to a half or a quarter and the cable by several sizes. Surge ratings, often twice the continuous rating for a few seconds, are covered by the fuse's time delay rather than the cable.

Common questions

What size fuse for a 3000 W inverter on 12 V?

About 400 A, which is 125% of the 294 A full-load input current. Check the inverter manual for its maximum.

Can I use 4 AWG for a 3000 W inverter?

4 AWG copper is rated 95 A at 90 °C. At 12 V the inverter needs about 368 A of ampacity, so 4 AWG works only at 48 V.

Sources

  • NFPA 70, National Electrical Code, 2023 edition (https://www.nfpa.org/codes-and-standards/nfpa-70-standard-development/70)
  • ABYC E-11, AC and DC Electrical Systems on Boats (https://abycinc.org/)