Wire size for 25 amps
A 25 amp circuit needs at least 10 AWG copper or 10 AWG aluminum at 75 °C. Long runs need more. Enter your distance and voltage to check.
Wire size
Fill in the circuit, then press the button.
Minimum wire for 25 amps
| Conductor | 60 °C | 75 °C | 90 °C |
|---|---|---|---|
| Copper | 10 AWG | 10 AWG | 10 AWG |
| Aluminum | 10 AWG | 10 AWG | 10 AWG |
NEC Table 310.16, not more than three current-carrying conductors, 30 °C ambient. 14, 12 and 10 AWG are capped by 240.4(D).
Most 25 A circuits land on 10 AWG copper or 10 AWG aluminum, using the 75 °C column. The 90 °C column is only a starting point for derating; the final ampacity cannot exceed the 75 °C value at the terminals.
How far can a 25 amp circuit run?
Maximum one-way distance at 3% drop with the circuit loaded to 20 A (80% of the breaker). Past these lengths, use the next column.
| Voltage | 10 AWG | 8 AWG | 6 AWG | 4 AWG | 3 AWG |
|---|---|---|---|---|---|
| 120 V | 72 ft | 115 ft | 183 ft | 292 ft | 367 ft |
| 240 V | 145 ft | 231 ft | 366 ft | 584 ft | 734 ft |
Copper. Three-phase rows use 1.732 in place of 2.
Other parts of a 25 A circuit
- Equipment ground: 10 AWG copper or 8 AWG aluminum (Table 250.122). Upsize it in proportion if you upsize the circuit wires for voltage drop.
- Typical uses: some window air conditioners and small heaters.
- Continuous loads: a 25 A breaker can carry 20 A continuously (210.19, 215.2).
Common questions
Can I use 10 AWG for 25 amps?
Yes, 10 AWG copper is rated 30 A at 75 °C, enough for a 25 A breaker as long as every termination is rated 75 °C and the run is short enough for voltage drop, about 145 ft at 240 V.
What size aluminum wire for 25 amps?
10 AWG aluminum at 75 °C. Aluminum drops more voltage than copper, so check long runs.
Do I enter the one-way length or the total wire?
Enter the one-way distance from the panel or source to the load. The calculator doubles it for the out-and-back path on single-phase and DC circuits, and applies the 1.732 factor for three-phase.
Related calculators
Sources
- NFPA 70, National Electrical Code, 2023 edition (https://www.nfpa.org/codes-and-standards/nfpa-70-standard-development/70)