Voltage Drop Calculator

HomeCircuits

Well pump wire size calculator

Enter the pump size, voltage and total cable length from the control box to the motor. Add the service factor amps from the label if you have them.

One way from the panel to the motor. Enter 0 to skip voltage drop.
%
Used for voltage drop. Leave blank to use the NEC table current.
A

Pump cable

Fill in the circuit, then press the button.

Two-wire vs three-wire pumps

Two-wire pumps have the start components inside the motor; three-wire pumps use a control box at the surface. Both run on the same size conductors, but the three-wire cable adds a yellow start lead.

Common questions

Why 5% for well pumps?

Submersible pump makers design their cable charts around a maximum of about 5% drop at the motor, since the motor's starting torque depends on it.

Sources

  • NFPA 70, National Electrical Code, 2023 edition (https://www.nfpa.org/codes-and-standards/nfpa-70-standard-development/70)